Cutting Vinyl Lattice With Hand Saw

Set the blade depth 0 5 in 1 3 cm wider than the lattice s thickness.

Cutting vinyl lattice with hand saw.

Cut through the lattice joint by joint using a circular saw with a vinyl cutting blade. The best saw blade for cutting vinyl lattice is one that has small straight teeth not teeth that are hooked or otherwise designed to rip and tear such as saw blades designed to cut through. I had to replace a couple vinyl lattice sections that w. On the other hand if you need to cut the plastic lattice into angles and curves you should use a power saber saw.

Adjust the blade depth on a circular saw by releasing the blade lever on the back. If necessary walk on the lattice to the side of the lumber opposite the saw and marked line. The width depth of the blade may offer a bit more straight. If you plan to make angled or curved cuts use a power saber saw.

Have your helper assist you in guiding. Squeeze the saw s trigger and move the circular saw slowly along the full length of the marked line. This is the easiest way to cut vinyl lattice that i ve come across and i wanted to share it with you. You can also use a trim saw or a handsaw.

If you have a helper a table saw is ideal. A fine blade back saw much like what s used in a miter box. Cut correctly be sure the lattice face side is upward when a fine toothed hard saw is in use. Position the circular saw blade at one end of the lattice sheet lining up the blade with the marked cutting line.

Ease the saw or blade carefully through the lattice. Remove the t square guide and the rip fence. Most of the people who usually need to do it regularly suggests using a circular saw and a sharp and new cutting blade. Pvc lattice can be cut with a hand saw circular saw table saw or just about any saw that cuts wood.

The best way to cut vinyl lattice is to use a circular saw and a cutting blade. Hold the saw against the lattice as if you were about to cut it then let the blade dip roughly 0 5 in 1 3 cm below the level of the lattice. Some are sold without the support spine allowing no angleing as you cut. In case you have to do a lot of cutting in straight lines with the plastic lattice the circular saw or power saw with the plastic cutting blade is your best option.