Cutting Vinyl Lattice Panels

The easiest method of cutting vinyl lattice is to grab your circular saw reverse the blade and cut away.

Cutting vinyl lattice panels.

That s simple enough right. Pvc lattice can be cut with a hand saw circular saw table saw or just about any saw that cuts wood. If the measurement falls over an opening lower the tape s position at the panel s edge until the measurement falls over a lattice strip. Any flat 8 ft 2 4 m 2 by 4 in 5 1 by 10 2 cm or 2 by 6 in 5 1 by 15 2 cm board can function as a work surface.

This will enable you to cut through the staples in the panels with ease. Mark the dimension on the lattice s surface with a pencil. Most of the people who usually need to do it regularly suggests using a circular saw and a sharp and new cutting blade. The reversed blade prevents the teeth from chopping through the vinyl instead allowing the smoother surface of the blade to somewhat melt through it.

I had to replace a couple vinyl lattice sections that w. A worktable or a sturdy plank will do the trick. Remove the t square guide and the rip fence. The most common materials which are used for making lattice are wood plastic pvc and polyvinyl chloride among these types the easiest material that you.

This is the easiest way to cut vinyl lattice that i ve come across and i wanted to share it with you. The best way to cut vinyl lattice is to use a circular saw and a cutting blade. You can also use a trim saw or a handsaw. Lattice is a beautiful form of design you can use to decorate your house.

If you don t have a vinyl cutting blade you can use another fine toothed blade. To cut vinyl lattice attach a vinyl cutting blade to the power saw. If you have a helper a table saw is ideal. Have your helper assist you in guiding.

Cut through the lattice joint by joint using a circular saw with a vinyl cutting blade. Place the lattice face down on a flat surface for cutting. Set the lattice on the surface with the front or the side with the faux wood grain facing down. It also enables you to cut accurately and effectively.

It is best to attach a carbide tipped wood blade to the power saw for a wooden lattice.